HOW TO USE

• 1 STEP SET MATERIAL

  Feed the material into the printer skin side facing up.

• 2 STEP PRINT & CUTTING

  • Select an existing design or create your own on the computer.
    (NB : Design must be mirrored.)
  • Change the machine settings according to the materials conditions.
    (If unsure, see the .PDF provided above.)
• 3 STEP WEEDING

  On a flat surface, take a weeder and remove any parts not neccesary.

• 4 STEP TRANSFER

  • In order to remove the design from PET, it must be attach to the adhesive side of MASK PAPER.
  • After application, it's essential to ensure there are no air bubbles and the design is firmly stuck to the adhesive side..
• 5 STEP PEEL OFF PET

  Peel off PET from the trasnfered to apply to your garment.

• 6 STEP PREHEAT & POSITION

  The ideal heating, pressure and time conditions for press can be seen in the photo above.

• 7 STEP HEAT APPLY

  Preheat the garment and arrange the transfered design in your desired placement and then press.

• 8 STEP PEEL OFF

  Gently remove PET from the top side of the design.

( *Disclaimer - These instructions may very according to the material and machine type used-for best results check the specifications. )