HOW TO USE

• 1 STEP SET MATERIAL

  Feed the material into the plotter machine hotmelt side facing up.

• 2 STEP CUTTING

  • Select an existing design or create your own on the computer
    (NB : Design must be mirrored.)
  • Change the machine settings according to the material's conditions
    (If unsure, see the PDF provided above.)
• 3 STEP WEEDING

  On a flat surface take a weeder and remove any parts not necessary for your design.

• 4 STEP PREHEAT & POSITION

  The ideal heating, pressure and time conditions for press can be seen in the photo above.

• 5 STEP HEAT APPLY

  Preheat the garment and arrange the weeded design in your desired placement and then press.

• 6 STEP PEEL OFF CARRIER

  Gently remove PET film from the top side of the design.

( *Disclaimer - These instructions may very according to the material and machine type used-for best results check the specifications. )